Corsa LET Dash light wiring

oli_p · 06-10-2008, 14:04

Right few of the dash warning lights dont work so will be going about wiring these up.
Ideally just need to know the colours of the wires and where too look for them.

Wanting to wire up the engine management light
The wire needed to flash the ecu codes up as will be wiring this into a switch
full beam warning light
and oil pressure light.

Cheers

oli_p · 07-10-2008, 10:41

anyone?

oli_p · 08-10-2008, 13:00

up. any idea for the engine management light at least??? and where abouts it would/should be??

Jam666 · 09-10-2008, 20:46

on my xe i connected a blue and a yellow wire to get my management light up..wish i didnt now as it stays on..is there anyway to get it to work properly? i.e come on wen ignition is on and then switch off wen running?

oli_p · 10-10-2008, 16:22

is this the same on the let aswell?? where is this wire most likely going to be located on both parts of the loom LET side and Corsa side.

Jam666 · 10-10-2008, 16:38

my wires were down in the driverside footwell where my new c20xe ecu was...im not sure if its the same on the let..but thats wat i did mate

oli_p · 12-10-2008, 17:12

anyone else have any ideas for the other things i need to wire up?? cheers

oli_p · 17-10-2008, 11:28

anyone else got any info for the ecu light on corsa b let?? on the plug for the clock (rev/speedo) i cant see a blue/yellow wire, i can see a blue/brow wire which looks as if it goes to the ECU light bulb on back of the clocks??