Any one got any ideas on how i could tidy up my engine bay!!
feck me thats a bit messy. basically, try and push all the rubber pipes down out of view there's not much else u can do with them unless ur gona lengthen them which is a bit of a chew on. for the wirin id lengthin it all so it runs round the edges of the bay where u could put it in some nice tidy piping then for the sensors lengthen them so where the run to the engine they drop down behind/around the engine then you can tape them up to the water pipes or various engine bits. then cable tie them up n it'll b fine
hope that makes sense
Fitting the 'turbo' cover over the inlet manifold would make things look much better aswell. Give the thing a damn good clean would help too!!
Different car I know, but the mk2 and mk3 are essentially the same under the bonnet.
"The more you turn the wick up the faster it goes" - John Welch