AS the thread title says:
Was running, backed it up the drive, did some work, nothing ignition/fuel side basicaly re-hang exhaust, drop sump, sort out oil pick-up etc.
Now the engine will not start.
It spins over very quickly on the starter, plugs (black electrodes) looked wet, dried them and no change, checked them again and they looked fine. No fuel on them.
There is good fuel pressure at the fuel rail and the pump is running fine.
The plugs are all sparking too.
The ECU is throwing up the following fault codes whixh according to the list I have are:
19 - Crank Sensor, but the engine is not running. Note though that it is still showing this code during cranking, it that normal?
66 - CO level potentiometer - Voltage High. - WTF?
93 - Hall effect Sender - Voltage High.
Anyone confirm these codes?
Would I be getting a spark if the hall sender was faulty?
Also when cranking the rev counter jumps all over the place, any gen?