Cambelt cover to pullys gap?
How much room is ther between the cambelt cover and the pullys?
I want to cut a hole out and put perspex behind it and have the pullys on show.
I was thinking about getting somthing machined into it so I can put leds at the side and then the machined bit would golw.
I need to know how think roughly the perspex could be.
well on a c16 xe you can have 5mm perspex no probs, sppose its the same for the xe?
why not go the whole hog and get a carbon one made with the perspex in
Because I have no other carbon bits on my cav only chromed bits.