Bias Relocation Kit
I have recently purchased a brake Bias valve relocation kit for my MK2 Astra GTE 2.0 16v
As the tapered 208 kit will be fitted onto the car very soon
And i was just wondering if anyone has put one of these kits together as all i have is a bag of bits with no instructions
I have a rough idea but if anyone has any advice, instructions or even some pics that will be great
braided stuff isn't too hard, you need a vice, a couple of spanners, some good cutters (to snip the braid), and a small sharp hacksaw & masking tape if you need to cut the hose to length.
put the threaded collar over the braid first, then flare the braid out a little and make sure the liner is cut cleanly and squarely - then tap the little olive onto the liner.
now get the main fitting and push it through the olive and into the liner - make sure the liner doesn't push out.
now trim the braid if it's a bit ragged or too long
now into the vice - push the collar up the hose until the threads engage, and start tightening up slowly - make sure the hose doesn't push out
now you're done
try the www.thinkauto.co.uk website - they might have an online guide, not sure.
Has anyone got any photos with this kit on there car