I've just bought an XE Cylinder Head to build up my engine, it has been stripped down bare and I am thinking about doing my own headwork. Having not done this before i was thinking about getting another Alloy head to practice with if i'm not sure. Below is a pic of what i think i may do to the inlet ports shape, and match to the manifold. What is the suggested tools i use to do the job? I have a power drill and some grinding stones, i'm not sure if a dremmel may be better though.
Any suggestions and help much appreciated.
I'm thinking about possibly enlarging the whole inlet port all round also but am unsure. Any suggestions to exhaust ports would be good too