Hi,i got a new ECU and transponder and chipped key to see if that was the problem with the engine.Thanks goes to AJBek for having a spare wiring loom and ECU after throttle boddying his corsa.Nice car mate.
Anyway after i stripped the wires (7 i think)quite close to the ECU to see if the immobiliser would work from there.
With the key lying next to it,it still wouldnt start.So after some messing about we then decided it would be best to try the other loom on the engine, as AJbek can guarantee it works.So after a busy couple of hours we nearly had all the new loom fitted.Only one problem was my old engine had two big multiplugs/one for the injection and one for the rest.
So after a bit of swapping around i had to take the inlet of to get to the injection wiring.
After stripping and reconneccting the looms,there wasnt very many changes in them at all,only some circuits were swapped from one of the looms to the other.
We then stripped the transponder out of the Corsa and took about six inches of wire with us.
I was just wondering if anyone knew how to wire the immobiliser up.
I think the colours are
Also as this is a new loom i will have to re solder everything onto this new loom from the Astra loom.
Valvers guide seems to be down and i dont know of anywhere else that has the wire colouring.
anyone have any ideas???