I am seriously considering going the supercharger route, but obviously for this I need to reduce compression.
The Enem kit comes with 2 headgaskets and a metal plate to go in the middle. I dont like this idea much, I would rather fit one thick headgasket if possible. I am not sure what the kit takes the compression down to - guessing at 9:1.
Is there an XE compatible gasket that would reduce compression to around 9:1?
What is the standard xe thickness and let Headgasket thickness?
I dont want to go fitting LET pistons and all that lark if possible.
I think Regal keep the compression standard, but their SC kit only runs 0.4/0.5bar and less power than the 0.8bar I am going to be using.
I will be fitting Aquamist System 1 Waterinjection at installation as a precaution against detonation.