The conversion is pretty much all done.
The XE is in the Cav and all wired up and turning over but I am getting no spark.
I have managed to source a 20XE coil with the right module from a motor that was running.
I am pretty confident I am getting fuel but I am not getting any spark.
I was wondering if there was a test I could do to see if its the coil thats faulty or if its the dizzy etc.
I also have a single wire left over. It comes from the engine bay loom (rather than the ECU loom) and is a single red (quite thick wire) with a round connector on the end that will slide down a bolt (like the ones that go on the battery terminal). I am pretty sure it didn't come off the battery terminal as I had not taken any of the others off. It has a "swinging radius" that means it could reach to the starter motor area but I am at a loss as to where it goes and whether or not it could prevent me from getting a spark.
Any gen would be very very very grately recieved.