ok now ive fitted my alarm n all works beautifully just about apart from i can't get the indicators 2 flash when i arm the alrm. the wiring from the alrm is 1 black/white wire and 1 black/green wire. i no these will connect to the indicator circuits but could some1 tell me the colour of the correct wires
okay tried the wires as said and got nothin ne ideas? the alarm is a toad a101cl if that helps. am goin 2 multimeter the wires later 2 make sure the correct 1's altho there the 1's the manual states. also just bin told on toad alarms it is possible 2 disable indicators and siren so am gona look into this all gen appreciated
Not sure about the Toad alarms mate, but i know on mine i can disable the indicator flash, the siren, pretty much everything.
Check the manual about this, it might be that u need to flick a switch or add a jumper to make the indicator flash active.
But all the above threads by myself and others are correct.
Green/Black to Green/Black
White/Black to White/Black
Although saying that, i dont think it matters what wire goes where in regards to the indicators, coz my ones from the alarm where both grey! After all they only make the left or right indicator circuit flash, so i dont think it matters too much.
Like i said before, i found the hazard switch easier to wire them to, but others prefer indicator stalk, the choice is yours! lmao