right, basically i have two questions,
firstly is a mk3 astra 1.4 mpi driveshaft the same as a mk3 astra 1.6 16v driveshaft in terms of the engine end of it
secondly, i need a driveshaft which will have 2.0 cav turbo ends and astra mk3 either 1.4 or 1.6 uppers into the engine, there fore, is it possible to sorta weld the end of a 2.0 cav turbo shaft on the hub end onto a mk3 astra shaft so that i can fit cav turbo breaks without a valver.
could an engineering firm do it? make a sleeve? simple welding?
any advice appreciated, and no1 to say get a valver engine and there wont be a problem.
thank you muchos