been battling away this week swapping a c20xe into corsa gsi.
had the hubs machined to fit the corsa bearings, and pressed back into the carriers.
the garage that pressed them said after doing one that they didn't come through far enough, but i couldn't see what the problem was.
anyway, started reassembling and the brakes don't go back on.
so matey at the garage was right and the hubs didn't sit into carrier far enough.
there's no way the caliper hanger is going over the discs now.
the worse thing is that i even told the garage to go ahead and press the other side.
so thats ***ked my chances of being ready for trax.
two brand new bearings are going to be ***ked, and now i need to either buy new hubs and try to have them machined again, or buy shafts that go into the corsa hubs, which no doubt wont arrive for ages, even if i order asap.
not very happy.