16, Knock sensor 1, No change in voltage
2.0 8V 130
Cheers. What do i do? Do i need a new one?
not sure, could be faulty wiring or connector,
i just know the codes, someone on here will of had the same problem, just wait for them to tell you what they did to fix it
2.0 8V 130
check to see if you have possitive feed coming down the wire to the knock sensor,if yes then wiring should be ok and you allmost certainly need a new sensor,but try this 1st,reset the ecu.take batt lead off 4 30 mins and then reconect,start car take for a little drive and then read codes again and it may have cleared.had this b4,also look 4 bad eath connections most common are fuel rail connections...
The light has only come on a few times. And in those few times it has gone off again shortly after.
if performance and fuel ecconomy is good dont worry unless it gets worse...
Yeah I had that. In the end the sensor gave up for good.Originally Posted by SriCrew
But the knock sensor wiring is also known to be troublesome.
Will just have to wait for it to get worse.
If it is the sensor, autovaux. Not an easy sensor to change on a 4x4