This morning I managed to remove the clutch cable from the actuating arm on my F28. I've adjusted it a few turns the only problem is I'm not sure how it should locate back into the arm.
It just seems to go over the end of the arm but not actually clip or be retained in, is this correct?
If I was to pull the clutch pedal up it stands a good chance of just falling out of the fork, surely not how its supposed to be?
Is the plastic on the "nut" supposed to go either side of the arm or just rest on the front face?
Diagram or photo showing correct monting would be appreciated.
Ps. this is all being done by feel as you can't see a thing down there!