I've got the passenger side front engine mount on, and the front bolt is done up, but i cant get a spanner to stop the rear bolt from spinning when doing it up. (for those of you that didnt read my other thread, i snapped off the captive nuts because it was rusted solid, and theres no way of reusing them).
Having a look under there, i noticed a small square hole on the other side of that pic, where the wheel arch side is.
Would there be a problem with enlarging the hole say by and inch so i can get the spanner in there?
Enlarging the hole by that little wouldnt make much difference to the chassis structure would it?