theres a hex section at the cambelt end of the camshaft, think its 24mm spanner or something. hold it there, undo the bolt in the middle of pulley. the pulley only goes on one way, its got a peg on the end of the shaft. no need to mark it.
Ok, all going well, I've changed the camshaft oil seals, but now I'm unsure how to put the cams back in, I've just replaced the lifters after cleaning them, and now the cams seem to be sitting all uneven on the lifters,
All seems to be going back together well apart from the bolt between the 2 cam pulleys for the cambelt cover has rounded off in the cam carrier,
All lifters cleaned, drilled holes breather mod done, new cam cover gasket, new camshaft seals, new distributor oil seal, new water pump, new tensioner and roller, and the new belt wil go on after some dinner!
Just got to fit injection rail back on and tomorrow I'll remove sensible 1.2 from crap nova and set about fitting the engine!