So can anyone help me out here,
Recently fitted direct to head QED setup on the XE but only have 255bhp map available. Now it is running but overfueling obviously. My engine is standard apart from magnex manifold and very short exhaust system, (rear engined). Can anyone help out with a more suitable map that at least will get me a better start prior to rolling road setup?
Log onto the DTA forum and there is a Map file page where you can download maps users have posted up. I think there are a couple of VX maps there, if you still have no luck with good running give me a shout as I have a few which may be of use.
BTW when you download a map from there make sure that all your values match those on the site as the new and old maps are constructed slightly differently on the injector opening side of things. Basically the newer maps allow for a greater degree of control over the opening times and so are accurate to a different number of decimal places.
i take it you have access to connect/upload to the ecu!!
you want wanna be drivintg it around running rich!!
Tried the fueling anywhere between 2 and 4 bar with little improvement.
I,m of down to QED on Friday to pick up the comms lead so as sugested I am gonna try and screw a map out of them, seeing as I'm paying £35 for the lead
Car is now laid up for winter so not being driven, but I'm probably taking in into John Nobles, (work 100 yds away), to get it set up, so I'd like to be able to drive it the 6 miles there without to much bother.
I really am a bit green when it comes to prog ecu's but a just want to get it fairly close so I can run it safely while I have a play about with the settings