hot to take corsa b interior bits off - please help :)

[bunnymofo]

how do i take these pannels off ?

i have taken out the 2 screws at the bottom but i cant see whats holding it at teh top.




and this one

[Nemesis]

Pop the air vents themselves out. On the bottom pic there's 2 screws behind the movable air vent bits

[bunnymofo]

ok. il have another go tomorro

[bunnymofo]

to pop out the airvents, do i just use a screw driver ?

[Nemesis]

to pop out the airvents, do i just use a screw driver ?

You have to pinch them. Basically there are 2 circular tabs either side of the vent. The vent pops into these tabs to let it pivot up and down.

[bunnymofo]

ahh ok. right, job for tomoro lmao thx for teh help

[Collateral]

The vents are B*stards to get out i warn you, when i colour coded my white corsa, i chipped so much paint getting them back in. If your doing it to paint the parts, i would strongly suggest against it !

[bunnymofo]

ahh, ok, not good then lol, i was gonna paint them white, then when i get around to it, spray teh car white with black bonnet. mayb i wont bother then if your sayin its so hard. i supose it would look a bit odd with just 3 buckets and a coulur coded dash lmao

[Collateral]

ahh, ok, not good then lol, i was gonna paint them white, then when i get around to it, spray teh car white with black bonnet. mayb i wont bother then if your sayin its so hard. i supose it would look a bit odd with just 3 buckets and a coulur coded dash lmao

I did mine white looool It gets dirty so quickly, its up to you, the beauty of the interior parts are they are cheap from a scrappy so if you mess it up its ok loool But i wouldnt do it again. Do it once by all means .... but it is a mission lol ^_^

[bunnymofo]

lool. i better not try it then, if it dosent work in liek 5 seconds il have a lump hammer and a pry bat at it haha. and yeah, didnt think of it gettin dirty. oily ands and stuff + white bits = fail lmao

[Collateral]

lool. i better not try it then, if it dosent work in liek 5 seconds il have a lump hammer and a pry bat at it haha. and yeah, didnt think of it gettin dirty. oily ands and stuff + white bits = fail lmao

LOL yep!

[bunnymofo]

lmaolmao iv just noticed how bad my typos hav got lmao

[Corsa Sleeper]

Hammer and the most important part ........ safety goggles lol

[bunnymofo]

lmaolmaolmaolmao hehe, very tru